Thursday, January 14, 2010

Rules: SCHOR PRO-MODIFIED CLASS...

SCHOR PRO MODIFIED  (The fast and the furious!)

The SCHOR Pro-Mod class is a little different than the Pro-Modified classes that you'll find in most of the large racing organizations.  The main difference is a boost in horsepower.  In SCHOR a Pro Modified can run armatures as hot as 2.5 OHMs.  This makes for a SMOKIN' FAST slot car that has no trouble pulling the level 25 magnets that have been on the scene for quite a while now.

The SCHOR Pro Modified Class HO racing class is open to racers of all experience levels as long as the entered car is in compliance with the following rules:


Must meet all SCHOR General and Super Stock 
rules except for the following:

1. Armatures may be rewound, trued, epoxied, balanced, etc. Single pole resistance for any armature cannot be less than 2.5 ohms (or 36 gauge arm) measured pole to pole at room temperature.


2. Helper springs or shims may be used in the Tomy endbell to insure proper motor brush tension, but cannot extend outside the endbell.

3. Motor ball bearings may be used. No shunt wires allowed.

4. Only Tyco 440x2 and Tomy Super G+ cars can be run in Restricted Open set-up (bonded polymer grade motor and tractions). No braces, drilling, screws or glue allowed unless specified.

5. Adjustable brush barrels, motor bushings, and chassis clips are allowed.

6. Motor magnets must be ceramic or ceramic-grade bonded magnets from BSRT or Slottech.



  The following chassis are approved Chassis for this class:
  • Slottech Thunder Cat & Slottech Panther
  • Tyco 440 X2 & BSRT T2
  • BSRT G3-R
  • Tomy Super G+
  • Wizzard Storm & Wizzard Patriot
  • DeCosmo T+ Chassis and/or Bulkheads


No comments:

Post a Comment